Background System Restrictions
The normal user of CTSS will not need to concern himself with the following section which is primarily of interest to those programmers dealing with older pre-time-sharing programs.
Certain programming conventions or restrictions must be followed in programs running as background jobs in CTSS. These restrictions are principally dictated by the need periodically to interrupt all programs operating in CTSS. Normally, well-programmed systems will already satisfy the requirements. What is required, in the main, is a program which is timing-insensitive (i.e., one which would operate correctly were the computer to be put in manual operation at any moment).
- The use of the following instructions is prohibited; if a system uses one of these instructions, a protection mode violation occurs and a diagnostic will be given.
ECTM LPI ESNT LRI ESTM SEA ETM SEB LCH TIB
- Data channel traps on channels A and B will operate normally except that when a trap occurs, instead of an effective XEC of location 13 or 15, control is transferred to location 13 or 15. Therefore, if data channel traps are expected, location 13 or 15 can only contain an unconditional transfer for proper program operation. (If this condition is not satisfied a diagnostic will occur.)
- The background system, if authorized by the Center, may use the Disk Control Subroutines (Chapter 5) by calls identical with those used by foreground programs.
- Since many foreground users may have programs operating, it is undesirable to have the operator intervene in the conventional manner to take terminal post-mortems. The "Load Cards" and "Load Tape" buttons are not to be used by the operator, since they reset the memory protection and relocation mode. The "Start" button cannot be used because the operator does not know when the background system is operating.
35
