in the sun." By Mr. Holder the apparatus is described as follows. "The potter's implements are few, and his mode of working is very simple. The wheel, a clumsily constructed and defective apparatus, is composed of several thin pliable pieces of wood or bamboo, bent and tied together in the form of a wheel about 3½ feet in diameter. This is covered over thickly with clay mixed with goat's hair or any fibrous substance. The four spokes and the centre on which the vessel rests are of wood. The pivot is of hard wood or steel. The support for the wheel consists of a rounded mass of clay and goat's hair, in which is imbedded a piece of hard wood or stone, with one or two slight depressions for the axle or pivot to move in. The wheel is set into motion first by the hand, and then spun rapidly by the aid of a long piece of bamboo, one end of which fits into a slight depression in the wheel. The defects in the apparatus are — firstly its size, which requires the potter to stoop over it in an uneasy attitude; secondly, the irregularity of its speed, with a tendency to come to a standstill, and to wave or wobble in its motion; and thirdly, the time and labour expended in spinning the wheel afresh every time its speed begins to slacken. Notwithstanding, however, the rudeness of this machine, the potters are expert at throwing, and some of their small wares are thin and delicate. The usual manner in which most of the Madras potters bake their wares is as follows. A circular space, about ten feet in diameter, is marked out on the ground in any convenient open spot. Small pieces of wood and dried sticks are spread over this space to a depth of about six inches, and a layer of brattis (dried cow-dung cakes) laid over the sticks. The vessels are then carefully piled on top of this platform of fuel to a height of about five or six feet,
