The Manchester and Salford docks were laid out on a precisely similar system, which was also adopted for the most recent docks at Dunkirk (fig. 6) and Prince’s dock at Glasgow (fig. 3), and at some of the principal Rhine ports; whilst the Alexandra dock at Hull resembles it in principle. The basins in tideless seas have naturally been long formed in accordance with this system (fig. 5). The Barry docks furnish an example of the special arrangements for a coal-shipping port, with numerous coal-tips served by sidings (fig. 8).
Tidal basins, as they are termed, are generally interposed in the docks of London between the entrance locks and the docks, with the object of facilitating the passage of vessels out of and into the docks before and after high water, by lowering the water in the basin as soon as the tide has risen sufficiently, Tidal and half-tide basins.and opening the lock gates directly a level has been formed with the tide in the river. Then the vessels which have collected in the basin, when level with the dock, are readily passed successively into the river. The incoming vessels are next brought into the basin, and the gates are closed; and the water in the basin having been raised to the level in the dock, the gates shutting off the basin from the dock when the water was lowered are opened, and the vessels are admitted to the dock. In this manner, by means of an inner pair of gates, the basin can be used as a large lock without unduly altering the water-level in the dock, and saves the delay of locking most of the vessels out and in, the lock being only used for the smaller vessels leaving early or coming in late on the tide. Similar tidal basins have also been provided at Cardiff, Penarth, Barry (fig. 8), Sunderland, Antwerp and other docks.
The large half-tide docks introduced at the most modern Liverpool docks (fig. 1) serve a similar purpose as tidal basins; but being much larger, and approached by entrances instead of locks, the exit and entrance of vessels are effected by lowering their water-level on a rising tide, and opening the gates, which are then closed at high water to prevent the lowering of the water-level in the dock, and to avoid closing the gates against a strong issuing current.
The tidal basins outside the locks at Tilbury and Barry are quite open to the tide, and have been carried down to 24 ft. and 16 ft. respectively below low water of spring tides, in order to afford vessels a deep sheltered approach to the lock in each case, available at or near low water (figs. 7 and 8). Such basins, however, open to a considerable tidal range where the water is densely charged with silt, are exposed to a large deposit in the fairly still water, and their depth has to be constantly maintained by sluicing or dredging.
Where the range of tide is moderate, or on large inland rivers, docks or basins are usefully supplemented by river quays, which though subject to changes in the water-level, and exposed to currents in the river, are very convenient for access, and are sometimes very advantageously employed in River quays.regulating a river and keeping up its banks when deepened by dredging. Generally 10 to 12 ft. is the limit of the tidal range convenient for the adoption of open basins and river quays; but the banks of the Tyne have been utilized for quays, jetties and coal-staiths, with a somewhat larger maximum tidal range; and a long line of quays stretching along the right bank of the Scheldt in front of Antwerp, constructed so as to regulate this reach of the river, accommodates a large sea-going traffic, with a rise at spring tides of 15 ft.
When a dock has to be formed on land, the excavation is effected by men with barrows and powerful steam navvies, loading into wagons drawn in trains by locomotives to the place of deposit, usually to raise the land at the sides for forming quays. Directly the underground water-level is reached, Excavations for docks.the water has to be removed from the excavations by pumps raising the inflowing water from sumps, lined with timber, sunk down below the lowest foundations at suitable positions, so that the lower portions of the dock walls and sills of the lock or entrance may be built out of water. A cofferdam has to be constructed extending out from the bank of the river or approach channel in front of the site of the proposed entrance or lock, so that the excavations for the entrance to the dock may be pushed forwards, and the lock or entrance built under its protection. Sometimes the lowest portion of the excavation for the dock can be accomplished economically by dredging, after the dock walls and lock have been completed and the water admitted.
Where a dock is partially or wholly constructed on reclaimed land, the reclamation bank for enclosing the site and excluding the tide has to be undertaken first by tipping an embankment from each end with wagons, protected and consolidated along its outer toe by rubble stone or chalk. When the ends of the embankments are approaching one another, it is essential to connect them by a long low bank of selected materials brought up gradually in successive layers, and retaining the water in the enclosure to the level of this bank, so that the influx and efflux of the tide, filling and emptying the reclaimed area, may take place over a long length, and in smaller volume as the low bank is raised. In this way a reduction is effected of the tidal current in and out, which in the case of a large enclosure and a considerable tidal range, would create such a scour in the narrowing gap between two high embankments as to wash away their ends and prevent the closing of the gap. Occasionally the final closure is effected by lowering timber panels in grooves between a series of piles driven down at intervals across the gap. On the closing of the reclamation bank the water is pumped out; and the excavation is carried on in the ordinary manner. It is very important that such an embankment should be carried well above the level of the highest tide which might be raised by a high wind; and in exposed sites, the outer slope of the bank should be protected by pitching from the action of waves, for any overtopping or erosion of the bank might result in a large breach through it, and the flooding of the works inside.
Docks are generally surrounded by walls retaining the quays, alongside which vessels lie for discharging and taking in cargoes. In order to ascertain the nature of the strata upon which these walls have to be founded, borings are taken at the outset to the requisite depth at intervals near the line Foundations for dock walls.of the walls, but inside the dock area if the piercing of quicksand is anticipated, as in excavating for the foundations, these holes might give rise to the outflow, under pressure, of underlying quicksand into the foundations. As docks are generally formed near rivers or estuaries, these strata are commonly alluvial; but being situated at some depth below the surface, they are usually fairly hard. When they consist of gravel, clay or firm sand, the walls can be founded on the natural bottom excavated a few feet below the bottom of the dock, their weight being somewhat distributed by making them rest on a broad bed of concrete filling up the excavation at the bottom. When, however, fine sand or silt charged with water, or quicksand is met with at the required depth, the necessary pumping and excavation for the foundations might occasion the influx of sand or silt with the water into the excavations, leading to settlement and slips; or the soft stratum might be too thick to remove. The wall may then be founded on bearing piles driven down to a solid stratum, and having their tops joined together by walings and planking, or by a layer of concrete, upon which the wall is built. Or the soft stratum can be enclosed with a double row of sheet piling along the front and back of the line of wall, by which it sometimes becomes sufficiently confined and consolidated to sustain the weight of the wall on a broad foundation of concrete; or it can be excavated without any danger of sand or silt running in from outside; whilst the sheet piling at the back relieves the wall to some extent from the pressure of the earth behind it, and in front retains the wall from sliding forwards. Firmer foundations have been obtained by sinking brick, concrete or masonry wells through soft ground to a solid stratum, upon which the dock wall is built. Clusters of small concrete cylinders, in sets of three in front, and a line of double cylinders at the back, were used for the foundations of the walls of Prince’s dock at Glasgow. Wells of rubble masonry were sunk in the silty foreshore of the Seine estuary for the walls of the Bellot docks at Havre; and they served as piers, connected by arches, for the foundations of a continuous dock wall above, being carried down to a considerable depth through alluvium at the St Nazaire, Bordeaux and Rochefort docks. These well foundations, derived from the old Indian system, are built up upon a curb, sometimes furnished with a cutting edge underneath, and gradually sunk by excavating inside; and eventually the central hollow is filled up solid with concrete or masonry.
 |
| Fig. 9.—Havre Bellot Dock Wall. |
The walls round a dock serve as retaining walls to keep up the quays; and though they have the support of the water in front of them when the docks are in use, they have to sustain the full pressure of the filling at the back on the completion of the dock before the water is admitted. They have, accordingly, to be increased in Dock walls. thickness downwards to support the pressure increasing with the depth. This pressure, with perfectly dry material, would be represented by the weight of half the prism of filling between the natural slope of the material behind and the back of the wall; but the pressure is often increased by the accumulation of water at the back, which, with fine silty backing, is liable to exert a sort of fluid pressure against the wall proportionate to the density of the mixture of silt and water. The increase of thickness towards the base used formerly to be effected by a batter on the face, as well as by steps out at the back; but the vertical form now given to the sides of large vessels necessitates a corresponding fairly vertical face for the wall, to prevent the upper part of the vessel being kept unduly away from the quay. Examples of the most modern types of dock walls are given in figs. 9 to 12.
The height of a dock wall depends upon the depth of water always available for vessels, at tideless sea-ports and at ports removed from tidal influences, such as Manchester, Bruges and the ports on the Rhine; this depth should not be less than 28 to 30 ft. for large sea-going vessels, together with a margin of 5 to 8 ft. above the normal water-level for the quays, and the foundations below. At tidal ports, however, an addition has to be made equal to the difference in height between the high-water levels of spring and neap tides; so that at ports with a large tidal range, such as the South Wales ports on the Severn estuary and Liverpool, specially high dock walls are necessary. Under normal conditions, a dock wall should
