The Sides of the hull (B, Figs. 52 and 53) are thin strips 2½ inches wide. Nail one to one edge of the bottom block, then saw off the bow end on a line with the bow of the bottom block, and the stern end on the same slant as the bevel cut on the stern of the bottom block.
Fig. 51.—Diagram of Hull.
With one piece in position, nail on the second side and trim off its ends. If you have any difficulty in making a neat joint between the bow ends of sides B, take a piece of tin from a can, bend it around the bow, and tack it in place as shown in Fig. 48. The stern piece (C, Figs. 53 and 54) should be cut next, to fit the slanted ends of the sides.
Figs. 52 and 53.—How the Hull, Sides, Stern and Deck Pieces are Assembled.
The Deck (D) extends from the bow almost to the center of the boat. Its top surface should taper in its length and curve from side to side. The piece may be whittled or planed to this shape. Fasten it with brads to the top edges of the sides of the boat.
