40
to be a repetition of the helmet of the head. The outer edges of the slab formed a border five to six cm. broad and 3 cm. high. The slab was broken in two pieces, the lower portion was found lying far from the upper one. The entire slab measured 182 cm. from the upper edge of the upper projection to the lower edge of the border below the feet; its breadth across the body of the figure was 74 cm. The length of the figure from the top of the head to the lower edge of the feet was 135 cm. The length of the face was 28 cm., its breadth 27 cm. The length of the breast-plate from the chin was 30 cm. The breadth across the shoulders 45 cm. The statue was found on the ground immediately north of the mound I; the lower piece was found west of the mound III.
κ
Pl. 32.
- Not mentioned by Squier.
Male figure in relief. Broken in several fragments and impossible to reconstruct. Only the face could be delineated. The face was well preserved and originally uncommonly well executed. It was quite expressive; the fore head was broad, not low, covered with a round cap or low turban; the eyes were narrow, elliptical, boldly cut; the nose was straight, broadening downwards; the mouth half open, with thin, but well-formed lips; the cheeks were lean, but carefully sculptured; the chin was broad and powerful. The ears were large, very prominent. The length of the face from the lower edge of the turban to the lower edge of the chin was 35 cm.; its breadth 26 cm. The thickness of the slab of stone was about 30 cm. Most fragments of this relief were lying at the western margin of the mound V.
λ
Pl. 32.
- Not mentioned by Squier.
Relief representing a male figure with the face of a skull. It was of much rougher workmanship than the reliefs before described. The face was
