Lay the blade flat on the further end of the strop, as shown in Fig. E, with the edge away from you. Draw the blade toward you, always keeping the heel of the razor in advance of the point. When at the end of the strop, rotate the razor on its back till the unstroped side of the blade comes in contact with the strop, as shown in Fig. F. Then, with the heel in advance, push the razor away from you, until it reaches the further end of the strop. Again rotate, and continue the stropping until the razor is sharp.
Always hold the blade at the same angle, and perfectly flat on the strop. You will observe that the stroke is exactly opposite to that used in honing. In honing, the edge is in advance; in stropping, the back. During the operation the back of the razor should never he taken from the strop. By observing this, and always turning the blade on its back, instead of on the edge, you will avoid cutting the strop.
Beginners should not attempt to make
